04-27-2007 01:11 AM - edited 03-05-2019 03:43 PM
Hi all,
how do we give only interface level config command access and show commands for usergroup using tacacs server.
Thanks in advance.
Rgds,
Rajeshac
04-27-2007 01:35 AM
Hi Rajeshac,
You can do so via 2 methods:
1. Configure the TACACS server to assign the user a certain privilege level, and then using the privilege command on the router, configure which commands can the user with this privilege level issue.
2. Configure the TACACS server to do authorization for the router, and configure the router to accept this command authorization, and then configure on the TACACS the commands that a user can issue. (recommended)
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804fde16.html
HTH, please rate if it does help,
Mohammed Mahmoud.
04-27-2007 03:37 AM
Rajesh,
You can also check out this cool attachment in the following post
HTH, rate if it does
Narayan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide