Switching

Hi i am working at a site with 4 1230 aironet access points & 1 ce 500 switch , there is no encryption / no authentication configured , all the devices are in the same vlan , the client devices are able to get the dhcp addresses & they get registered...

Hi,I am sending to ask about the ISR security bundles which is more expensive than the regualar software. So, If I want to implement mainly the firewall features plus NATing on my ISR router, I know that the regular router software can do it, but wha...

I've setup a 1721 on an adsl connection. Everything works ok except the local dhcp server. Its setup as per all the proper cisco documentation but for some reason it just will not serve addresses to client pc's.Ive ran a dhcp debug and tried an ipcon...

I have three vlans on a 3750: 50, 51, and 52. I currently have ip routing enabled and all traffic is routing between the three vlans okay, but now I want to limit traffic to vlan 50 (use 50 as the management vlan and 51 and 52 for access vlans). do...

Hi,the following error message i get with the working ASA & also tried on a newly bought ASA.i tried issuing "ciscoasa(config)# nat (inside) 0 access-list cbaynonat", the command accepts then added "access-list cbaynonat extended permit tcp host 172....

Hi I have configured Cisco Switch to do 802.1x authentication of Symantec NAC Agents. I am expecting Dynamic VLAN Switching when the authentication passes or fails.Switch = 192.168.0.124Symantec Radius Server = 192.168.0.56Client MAC = 00-0F-1F-BD-B7...

Hi.I have cisco 2611 and 2 NIC cards.Also i have 2 ISP.How i can use this ISP for backup route ?Sample:ip route 0.0.0.0 ISP1ip route 0.0.0.0 ISP2Sorry for my english.

Hi all,Is there any way of changing the Administrative Distance for a Directly Connected route?I have tried this, but not working:interface Ethernet0/0 ip address 10.9.1.100 255.255.255.0 interface FastEthernet0/0 ip address 172.20.254.254 255.255.0...

Hi, We have a Catalyst 4506 with 3 WS-X4306-GB modules.We need to connect a UTP GigabitEthernet. My question is? Do exists GBIC for this module with copper support (utp cat6).

Hi to all, i'm triyng to use VRF-Lite with shared service.I tried to configure two different VRF (blue and red for example) and then i configured another vrf (for example server). I tried to export with route-target both vrf blue and green to vrf ser...

HI allI am finding a way to shaer the internet access at my work cubicle. My cubicle only has one internet line with ethernet cable.I have few computers/servers and a laptop to connect to internet.I am finding a way to configure cisco 2900 swithc to ...