09-09-2021 06:54 PM
hi guys
I wanna know that how to check HA, and HSRP??VRRP?? interlink on cisco Backbone
HA, load balancing are working properly?? how do i check??
detailed information(command) will be very welcomed...
Thanks.
09-10-2021 12:23 AM
Not sure what is this device ?
HSRP or VRRP, it only use one active gateway to send traffic, it will not Loadbalance, One will be Active another one be Slave, wait for the Active to Fail to take over the Role of Active.
#show standby - hsrp give you information#show vrrp -
09-10-2021 03:21 AM
Hello @haedongchan ,
HSRP and VRRP are First Hop Redundancy protocols that are used on SVI of user facing VLANs / IP subnets.
In the backbone one or more routing protocol is in use.
So the answer for the backbone depends on what routing protocols are in use.
However, to check if load balancing is occurring for a destination prefix is enough to use
show ip route <prefix>
if the output shows multiple paths and multiple next-hops load balancing is happening for the prefix
note: you may be using HSRP or VRRP with static routes at border devices connecting to firewalls or to devices not under your administration. But this is no part of your backbone it can be your internet edge network block.
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide