07-24-2022 01:30 PM
Hello,
I am doing a project over Cisco Packet Tracer and it says "using the proper ethernet cable type, connect GigabitEthernet9/0 on the Main-Office-Router to the GigabitEthernet9/1 on Switch-01." However, when I clicked on the Switch-01 with the copper straight-through on the diagram through Cisco Packet Tracer, only FastEthernet2/1 and FastEthernet3/1 show up. What can I do from the picture I attached of what I'm looking at?
07-24-2022 01:33 PM
how you know the port is down ?
07-24-2022 09:51 PM
Hi,
to verify if port is down/up
Go to CLI tab >>
then type this command: show interfaces [interface id].
in your case:
Switch#show interfaces gigabitEthernet 9/1
GigabitEthernet9/1 is up, line protocol is up (connected)
Hardware is Lance, address is 0006.2a1d.8a12 (bia 0006.2a1d.8a12)
BW 1000000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:08, output 00:00:05, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
956 packets input, 193351 bytes, 0 no buffer
Received 956 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2357 packets output, 263570 bytes, 0 underruns
0 output errors, 0 collisions, 10 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Switch#
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide