traceout command

[WEERAKOO69BA]

hi..simple question,

how to apply traceout command ....on the pc or router??

what is the command

thx

[Reza Sharifi · Accepted solution]

Hi,

On router

T-1#traceroute 10.0.3.3

On Pc

tracert 10.0.3.3

HTH

Reza

[WEERAKOO69BA]

thnaks Reza

[Ganesh Hariharan · Accepted solution]

hi..simple question,
how to apply traceout command ....on the pc or router??
what is the command
thx

Hi,

The Linux traceroute command is similar to       the Cisco router implementation. However, it uses a fixed source port. The       -n option in the       traceroute command is used to avoid a request to a       name server.

where as in PC like windows tracert command is used followed by ip address.

Check out the below link hope that helps

http://www.cisco.com/en/US/tech/tk364/technologies_tech_note09186a00801ae32a.shtml#lin

Remember to rate the helpful post

Ganesh.H

[WEERAKOO69BA]

Thanks Ganeshh

[Ganesh Hariharan]

Hi,

That great the comments are helpful it will be great if you mark this thread as answered so that others get benifitted.

Ganesh.H