12-20-2012 08:57 AM - edited 03-07-2019 10:43 AM
Hi everyone!
I have an issue that I can't figure out. I have two cisco asa firewalls connected through a VPN, one is 5505 and the other is a 5510. From the 5505 I can ping the internal interface of the 5510, but not vice versa. Would that be a NAT issue? I used the ASDM to configure the VPN tunnels with the wizard for IPsec site to site.
Any suggestions?
Thank you
12-20-2012 08:59 AM
Make sure the management interface is configured for inside. Otherwise, it's going to be hard to say what the issue is without seeing the config.
HTH,
John
*** Please rate all useful posts ***
12-20-2012 09:08 AM
Similar to John's post, is the 5510 configured with the management-access
12-21-2012 05:10 AM
Ok, I will make sure on the 5505 that the manage interface is the inside interface. The 5510 is configured for other VPNs and it is working well. I made the VPN tunnel and it is connected, I added the NAT Exemtions on both firewalls, but like I said, can ping the inside interface of 5510 from a computer behind the 5505, but I can't ping back from the 5510 or any computer behind it. I will post the config for the 5505 later on. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide