Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone!I have an issue that I can't figure out. I have two cisco asa firewalls connected through a VPN, one is 5505 and the other is a 5510. From the 5505 I can ping the internal interface of the 5510, but not vice versa. Would that be a NAT is...
I manage three Netgear switches that I would like to upgrade to cisco switches, if it is possible to a faster or better performance switch.The current switches have the following specs. http://netgear.com/business/products/switches/fully-managed-swi...
Hi everyone! I'm reviewing ACLs for the CCNA. I had a question in the practice certification exam # 1 in cisco.netacad asking me to block telnet in three statements with an extended ACL. I answered this:access-list 100 deny tcp any any eq telnetacces...
I'm taking a CCNA class and a classmate asked me why we have to begin the statements with the same command for the same access list? Would not be better to have a configuration mode for the access list you just created? For instance, when you want to...
Ok, I will make sure on the 5505 that the manage interface is the inside interface. The 5510 is configured for other VPNs and it is working well. I made the VPN tunnel and it is connected, I added the NAT Exemtions on both firewalls, but like I said...
I based my answers in the little acknowledge I have from CCENT, so correct me if Im wrong here.I would change the IP addressing scheme. If your router is 192.168.1.1/24 then try to design all the subnets within the same class. I don't think Vlan 3 is...
