10-02-2023 03:03 AM
Hi...
I have a Switch where I can't enter LLDP commands on the Switch.
Model: WS-C2960G-24TC-L
SW Version: 12.2(35)SE5
I need this command to be detected from other brands of Switch.
Does anyone have any info/ideas about this case?
Thanks in advanced
10-02-2023 03:21 AM
Hello!
The SW version seems kinda old so I would recommend an upgrade to . But the switch should still be able to do lldp. Have you enabled lldp globaly and on the ports?
Globaly:
lldp run
on interface:
lldp transmit
lldp recive
to check:
sh lldp neighbors
BR
10-02-2023 03:25 AM
- Upgrade to https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_53_se/configuration/guide/2960scg/swlldp.html , at minimum ; then try again ,
M.
10-02-2023 07:12 AM
Cisco was late to support LLDP as they already had CDP. So, very likely in such an old IOS version, LLDP isn't supported. As also suggested by the other posters, try upgrading your IOS.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide