Looking for help with configuring PACL on ws-4506 switch. Successful with configuring ip access-list extended - name - in but unable to configure ip access-group - name - in on switchport interface.
I can configure PACL on a 3750 and a 4507's without issue but not 4506 with image cat4000-is-mz.121-12c.EW1.bin"
Thanks for any advice..
Hi Minermans,
What Supervisor engine you are using ?
Please note :- As per cisco document " Supervisor Engines III and Supervisor Engine IV running on a Catalyst 4500 series switch support both input and output PACLs on an interface ".
Hope it Helps..
-GI
Rate if it Helps..
What is the Supervisor engine running in 4506 ?
Note :-
