cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
805
Views
1
Helpful
5
Replies

Unable to enter our credentials on IE4000

frankawit8
Level 1
Level 1

Hello 

I am a newbie in network, I just want to ask help regarding the issue where I can't log in to our IE-4000-8GT8GP4G-E.

Also the "power supply vee under voltage and lockout" is keeps on showing and I think because of that error message that's why we can't log in.

What can I do with this?

2 Accepted Solutions

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame

@marce1000 and @balaji.bandi already gave you te information, but a little brief

power down the device and power on again
the collect the log from power-on until the repeated message repeats itself

most likely the power supply used is faulty
because of this the IE400 never fully boots up, so you never get to a login prompt
so above log is all you can collect

if possible exchange the power supply and test again

View solution in original post

5 Replies 5

marce1000
Hall of Fame
Hall of Fame

 

            - Start by providing correct power to the device ,

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Yes sir Actually two of our switch were experiencing like this, our IE SW1 is for RMA right now since we got the logs, the IE SW2 is we can't access or log in using our credentials. I need to access first on the switch to gather logs. What can I do is there a way please help me sir.

@marce1000 and @balaji.bandi already gave you te information, but a little brief

power down the device and power on again
the collect the log from power-on until the repeated message repeats itself

most likely the power supply used is faulty
because of this the IE400 never fully boots up, so you never get to a login prompt
so above log is all you can collect

if possible exchange the power supply and test again

Thank you. I will note this as my work- around 

balaji.bandi
Hall of Fame
Hall of Fame

May be worth connecting console cable and check - is the device booted as expected.

Look at the installation guide :

https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie4000/hardware/installation/guide/xml/b-cisco-ie-4000-hig/m-configuring-the-switch-with-the-cli-based-setup-program.html?bookSearch=true

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help