02-14-2020 03:23 AM
Hi
I can't able to ping via L3port-channel to another access layer switch VLAN interface.
For refer cmd.
Below for both iosvl2-1 & 2 >>
sh etherchannel sum
ping report >>
Solved! Go to Solution.
02-14-2020 03:55 AM
iosvl2-3 does not have a route for 200.1.1.0/30
iosvl2-4 does not have a route for 100.1.1.0/30
Either configure them to participate in EIGRP or configure their default routes to direct traffic to the routers at the top of the topology, depending on side.
iosvl2-3 --> iosvl2-1
iosvl2-4 --> iosvl2-2
cheers,
Seb.
02-14-2020 03:34 AM
Hi there,
The VLAN200 SVI on iosvl2-4 is 200.1.1.2 not 200.1.2.2 . You are pinging the wrong address. Try:
ping 200.1.1.2
cheers,
Seb.
02-14-2020 03:38 AM
the previous one has a typo error ping
now, here we go..
02-14-2020 03:55 AM
iosvl2-3 does not have a route for 200.1.1.0/30
iosvl2-4 does not have a route for 100.1.1.0/30
Either configure them to participate in EIGRP or configure their default routes to direct traffic to the routers at the top of the topology, depending on side.
iosvl2-3 --> iosvl2-1
iosvl2-4 --> iosvl2-2
cheers,
Seb.
02-14-2020 04:05 AM
Did It, enabled route at both of end. now can able to reach all of them
Thanks to Deb Rubik..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: