05-15-2012 09:35 AM - edited 03-07-2019 06:43 AM
I seem to have managed to set a 2960 to 230400 baud in the boot loader. Is there anyway to reset the variables in the boot loader? Maybe a set of pins to short? I can't access the console port reguardless of what I set the rate too. I've tried both the USB console cable and a USB to serial. Is there anything I can do short of an RMA?
05-15-2012 10:00 AM
It is little tricky, you can use aux port with xmodem commands and configure speed for the baud rate you need on line con 0 from there.....
---
Posted by WebUser Neeraj Jagga from Cisco Support Community App
05-15-2012 10:03 AM
To my knowledge the 2960 doesn't have an AUX port. Great ideal though. I've got a usb console port, serial console, management and the USB port.
05-15-2012 04:21 PM
Can you telnet/SSH into the appliance?
05-17-2012 08:05 PM
Andrew,
You may have to do a password recovery procedure on this switch. See link below. This should bypass your startup config so you can set to your normal 9600 and get into the switch. Hope this helps.
Ryan
09-12-2013 05:12 AM
after command
set BAUD 23400
console speed set to ~17000 !
BUG
05-11-2018 04:18 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide