04-27-2010 05:26 PM - edited 03-06-2019 10:50 AM
Hi! i create somes users with level 15 of privilege but i can only access with the admin user using ssh, telnet o http service. When i try using other users i can not access. Thank
Solved! Go to Solution.
04-27-2010 07:38 PM
have you enabled telnet ssh under the vty lines:
line vty 0 4
exec-timeout 60 0
privilege level 15
password damian
login local
length 35
transport input telnet ssh
And try again.
04-27-2010 10:40 PM
Hi! i create somes users with level 15 of privilege but i can only access with the admin user using ssh, telnet o http service. When i try using other users i can not access. Thank
Hi,
Check out the below link on local database configuration for line vty ,ssh etc.
Hope to Help !!
Ganesh.H
Remember to rate helpful post
04-27-2010 06:31 PM
Damian,
Is this an IOS router, switch?
Do you have the SSH, telnet, HTTP services authenticating against the local database?
Federico.
04-27-2010 06:45 PM
Is a switch (2960), how can i associate the users with the local database?
Thank
04-27-2010 07:20 PM
Hi Damian,
If you create a user name without using a any authentication server it will be assassinated with a local database:
example:
username damian privilege 15 password damian123
This will give full privilege to the switch
HTH
Reza
04-27-2010 07:32 PM
OK, but my problem is that the user can not log in using ssh, telnet or http.
04-27-2010 07:38 PM
Aside from creating the internal user database, you need to check that the SSH, HTTP, telnet, ect authentication is defined
to use local authentication.
For example, for HTTP you need:
ip http authentication local
For SSH and telnet you have to reference the lines vty to local authentication as well.
Federico.
04-27-2010 07:38 PM
have you enabled telnet ssh under the vty lines:
line vty 0 4
exec-timeout 60 0
privilege level 15
password damian
login local
length 35
transport input telnet ssh
And try again.
04-27-2010 10:40 PM
Hi! i create somes users with level 15 of privilege but i can only access with the admin user using ssh, telnet o http service. When i try using other users i can not access. Thank
Hi,
Check out the below link on local database configuration for line vty ,ssh etc.
Hope to Help !!
Ganesh.H
Remember to rate helpful post
09-23-2010 09:07 AM
I try but the command "login local" does not exist.
I have
Ports Model SW Version SW Image
WS-C2960-24TC-L 12.2(35)SE5 C2960-LANBASEK9-M
I can not add a user with the same priv than admin.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: