Using the built-in switch on a Cisco 1801W router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2013 03:58 PM - edited 03-07-2019 12:39 PM
Greetings!
I have a Cisco 1801W router, running a DSL connection with wireless connectivity for a school.
This is configured on the fastEthernet0 interface on the 192.168.1.0 network (the router is 192.168.1.1).
I was wondering if it is possible to get the built-in switch (fastEthernet 1-8 interfaces) to be used as a part of the same network (192.168.1.0/24).
Is that possible?
If so, does anyone have any sample configurations for this?
Fastethernet0 is connected to the school's main switch (24 port), but we could use a few more ports. I'd love to use the 8 ports on the router.
Thanks,
Bill
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2013 04:33 PM
Bill,
Looks like you just assign the ports to a vlan.
Mike
