cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1226
Views
0
Helpful
4
Replies

Using Xconnect l2tp with 3 locations

Hi there,

i am trying to do below scenario. i tried to configure it with my solution. but its not worked. any idea from experts?

requirement :

                        L2 Network                            L3 Network                              L2 Network

                                                          ------------------------------------------- router 2 ------------ Client Device 0

                                                         /

Central Device ------------------ router 1 --------------------------------------- router 3 ------------ Client Device 1

Central device and client devices need to be in same Layer 2 network with same IP range. i configured client device 0 network using  xconnect between router 1 and router 2. due to only one xconnect command can have per interface i cannot configure network for router 3. so i came up with below network as a experiment.

                        L2 Network                            L3 Network                              L2 Network

                                                          ------------------------------------------- router 2 ------------ Client Device 0

                                                         /

Central Device ----Switch==== router 1 --------------------------------------- router 3 ------------ Client Device 1

I connected switch to router using 2 links and those two interfaces in router configured with 2 xconnect commands. 1 tunnel came up and second tunnel not shows any packet moving through it.

please let me know if you have any idea. 

thanks in advance for looking in to this

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB
1 Accepted Solution

Accepted Solutions

Hi Kasun,

This link could be useful:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SY/configuration/guide/sy_swcg/vpls.pdf

:-)




>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

View solution in original post

4 Replies 4

Hi Kasun,

L2TP VPN is a point to point method, you could have multipoint using VPLS or HVPLS. Unfortunately L2TP will not work to interconnect 3 or more locations. 




>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

Hi Julio,

thanks a lot for reply. is there any documents for VPLS, HVPLs?

thank you

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Hi Kasun,

This link could be useful:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SY/configuration/guide/sy_swcg/vpls.pdf

:-)




>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<

thank you julio

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco