09-28-2020 01:50 AM
Hello everybody
I have a problem for stack switches that can't connect, the problem is v-mismatch
noted that the ios version is the same, but my question is:
the system boot version is different, is that the problem cause? and how to solve
also, the H/W version is a mismatch, and how we can solve it?
Solved! Go to Solution.
02-24-2022 04:34 PM
this worked for me on 9300. Thanks!
I left the system, and it reboot the required switch itself
08-01-2022 02:45 PM
Hello
please can you tell me the commands to pass the 2 sw to installation mode
Thank you
08-01-2022 04:06 PM
03-24-2022 05:58 AM
Install bin file first on new switch
CONF T
boot system switch all flash:packages.conf
Wr
Show boot system
The following has to Extract the IOS (unzips file)
switch# install add file flash:cat9k_iosxe.17.03.03.SPA.bin activate commit
reload new switch
12-05-2023 02:34 AM
I have a hardware mismatch problem in the stack switch and my all 3 9200 are in bundle mode, my stack is up.
but how to correct his or what issue will occur with this not matching.
12-05-2023 06:34 AM
Hi,
the preferred is install mode, you can do it as the above procedure, but it will work also in bundle mode
be aware that the service should interrupt during the process, and may take some time
best regards
12-07-2023 05:39 PM
apply "install autoupgrade", then it will upgrade mismatch member from one of the good members.
05-13-2024 08:58 PM
@David Ding1 wrote:
apply "install autoupgrade", then it will upgrade mismatch member from one of the good members.
The command is only supported in Install Mode and the command will not work if someone is trying to add mix-mode into stack.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide