cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
572
Views
0
Helpful
4
Replies

VACL support on 3560E

Curtis Griffin
Level 1
Level 1

Configuration option for 'vlan access-map' and 'vlan filter' are not available, though Feature Navigator says VACL is supported by the platform and release. 

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 30    WS-C3560X-24       12.2(55)SE3           C3560E-UNIVERSALK9-M    

sw1(config)#vlan ?

  WORD      ISL VLAN IDs 1-4094

  dot1q     dot1q parameters

  group     Create a vlan group

  internal  internal VLAN

sw1(config)#^Z

Am I missing something?

1 Accepted Solution

Accepted Solutions

Your license level is lanbase and not ipbase.

These command would be supported if you had ip base license.

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

HTH

View solution in original post

4 Replies 4

Reza Sharifi
Hall of Fame
Hall of Fame

This may be a license issue. What is your license level?

Can you post the output of "sh ver" and "sh lice"

Switch(config)#vlan ?

  WORD        ISL VLAN IDs 1-4094

access-map  Create vlan access-map or enter vlan access-map command mode

  dot1q       dot1q parameters

filter      Apply a VLAN Map

  group       Create a vlan group

  internal    internal VLAN

Switch(config)#vlan

HTH

Wondered that - but didn't see anything in the feature navigator to indicate it.  Running 'ipbase'

sw1#sh lic

Index 1 Feature: ipservices    

        Period left: 8  weeks 4  days

        License Type: Evaluation

        License State: Active, Not in Use, EULA not accepted

        License Priority: None

        License Count: Non-Counted

Index 2 Feature: ipbase        

        Period left: 0  minute  0  second 

Index 3 Feature: lanbase       

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

        License Priority: Medium

        License Count: Non-Counted

...

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

...

Your license level is lanbase and not ipbase.

These command would be supported if you had ip base license.

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

HTH

Joy.  thanks for the quick response.

Review Cisco Networking products for a $25 gift card