05-12-2013 05:39 AM - edited 03-07-2019 01:19 PM
Dear Experts,
I'm trying to get the VFC up in B22-FEX blade in Dell whic is connecting to Nexus 5596UP.
Could you take a look at this and help please.
Attaching the config of 5596UP
The message I get is
# sh int vfc1033
vfc1033 is down (Error Disabled - VLAN L2 down on Eth interface)
Bound interface is port-channel3
Hardware is Ethernet
Port WWN is 24:08:00:2a:6a:0d:db:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 2
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
last clearing of "show interface" counters Wed Mar 4 10:27:35 2009
!
Ethernet1/3 is up
Dedicated Interface
Belongs to Po3
!
port-channel3 is up
Hardware: Port-Channel, address: 002a.6a0d.db0a (bia 002a.6a0d.db0a)
Description: SIT_DellB22_C1
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is fex-fabric
05-12-2013 07:53 AM
Additional information below.
When port-channel 3 is set to switchport mode fex-fabric the VFC changes to error disabled, but FcOE channels (1-15) changes to UP
When port-channel 3 is set to switchport mode trunk, the VFC changes to UP, but FCoE channels changes to down.
05-12-2013 03:13 PM
Duplicate post.
05-13-2013 06:13 AM
Both VFCs and FCOEs are up now.
(There was an issu in binding to interfaces.)
Still not reading the WWNs and MACs from B22/Qlogic/DellM1000e
LACP is enabled.
Vlan 1 is native
Please let me know of any info on how to read WWN and MAC details.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide