04-07-2019 03:27 AM - edited 04-07-2019 03:27 AM
Hi ,
I need to setup Stack of four switches as per mentioned below.
WS-C3850-24T-S--- 2QTY
WS-C3850-12S-S---2QTY
currently i have 1 switch(C3850-24T-S) & 1 switch(C3850-12S-S). now i need to setup stack of 2 switches, my doubt is can i able to give "member number 3" to 2nd stack switch as i am planning to configure "member number 2" in future on another switch because of stock unavailability. I need to actually keep reserved this "member number 2" for another switch.
is it possible??
Solved! Go to Solution.
04-07-2019 06:50 AM
Connect switches using stack cables than use the command switch 2 renumber 3.
04-07-2019 04:11 AM
before you proceeding further, have you looked your model support Virtual Stack ?
below guide for Virtual stack support models and IOS, please do refer :
04-07-2019 04:20 AM
Yes.
available Switches supports stacking.
04-07-2019 06:50 AM
Connect switches using stack cables than use the command switch 2 renumber 3.
04-07-2019 07:18 AM
Just to confirm, are we discussing here Virtual Stacking or Stacking ? (sounds like your subject line mentioned that you look virtual Stacking) ?
04-07-2019 08:15 AM
It's stacking...
04-07-2019 10:40 AM
Ok sure that make sense, configure exiting switch with Switch numbers, and priority. make sure you decide which one need to ba master switch all the time.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide