10-16-2006 12:41 AM - edited 03-05-2019 12:15 PM
Hi
flash:c870-advipservicesk9-mz.124-6.T2.bin
I'm having real trouble getting a working configuration on a Cisco 877 that is to be used for sharing an ADSL connection between two small offices.
The offices will use seperate vlans, 192.168.31.0/24 (vlan1) and 192.168.99.0/24 (vlan2).
I have two cheap Netgear switches, one connected to FE1 (default vlan1) and the other to FE2, where I have issued...
interface FastEthernet2
switchport access vlan 2
switchport mode access
Running 'show ip inter brief' always shows the 'Status' and 'Protocol' as down.
My config is attached, if anyone has any useful suggestions.
Many thanks
Gareth
10-16-2006 01:29 AM
Hi
As per the datasheet it supports 4 Vlans with advanced ipservices image.
Would suggest to check whether the other end is up and live.
regds
10-16-2006 01:53 AM
Hi
Thanks for the reply.
The other end (a 5 port Netgear switch) is up and fine.
If I didn't connect a switch, and just connected my laptop directly into the FE2 port, would the configuration need to change?
I notice that when I issue..
switchport mode access
... on the FE2 interface, it does not stay visible when viewing the running config - is this normal?
Many thanks
Gareth
10-16-2006 04:16 AM
Hi,
Will you please issue the following commands:
vlan database,
vlan 2,
exit,
and see if there is any improvement.
Best regards,
Antonin
10-16-2006 05:11 AM
Hi
I entered those commands, but it did not improve the situation.
The FE2 light /led on the front of the router is illuminated, but the IOS shows the status and port as down.
Thanks
Gareth
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide