I can’t get my lab switch non-primary VLAN’s to be able to ping my lab router. Only switch VLAN 1 (default) is able to ping the router interface.
I have a home lab with a Cisco SG300-10 switch and an EdgeRouter-X router, which is connected to the rest of the home network. I can only reach the lab router, and thus the internet, only from VLAN 1, all others cannot ping the switch but can each other. I’m under the assumption that the lab switch which is in L3 mode should route the VLAN traffic to the router. What’s wrong with my setup or config? Note, i tried to set the lab router eth1 to 10.10.1.1/16.
Thank you for your help.