Voice VLAN 10 and Data VLAN 20 | same switch port | laptop over ip ph

[vinothsaravanan148]

Hi All

Please help me, guys.

I have configured the cisco business 350 series switch as below.

My requirement
Voice VLAN 10 and Data VLAN 20
I need to carry both VLANs since I'm using a Laptop over an IP phone
So used the CMD in all switch ports "switchport general allowed VLAN add 30,80 untagged"
It's working fine too.
But the problem is when I unplug the IP phone and connect the laptop directly to the same port, it does not work.

what is configured 

interface GigabitEthernet2

switchport general allowed vlan add 30,80 untagged

What its showing after I connect the port

interface GigabitEthernet2

storm-control broadcast level 10

storm-control multicast level 10

port security max 10

port security mode max-addresses

port security discard trap 60

spanning-tree portfast

spanning-tree bpduguard enable

switchport mode trunk

switchport general allowed vlan add 30,80 untagged

switchport trunk allowed vlan 1,30

macro description ip_phone_desktop

!next command is internal.

macro auto smartport dynamic_type ip_phone_desktop

Thank you in advance for help

Vinoth Kumar

vinothsaravanan148@gmail.com

[balaji.bandi]

look at the below thread :

https://community.cisco.com/t5/small-business-switches/sg350-28p-voice-and-data-vlan-config-on-a-single-port/td-p/4008018

Somehow users are input here, the macro does not work as expected, worth disabling the macro auto and doing the traditional config.