Hi everybody,
I have configured 2 6509E chassis with two 2T supervisors in each chassis. We are using de IOS version 15.1(1)SY.
We have a VSL with 2 TenGig interfaces.
After to apply the command : switch convert mode virtual , the Sup Standby in each chassis become to ROMMON mode.
When I connect to the console of sup (rommon) and apply the command boot, it received this message:
System detected Virtual Switch configuration...
Interface TenGigabitEthernet 2/5/4 is member of PortChannel 20
Interface TenGigabitEthernet 2/5/5 is member of PortChannel 20
Firmware compiled 11-Sep-12 14:49 by integ Build [26624]
*Apr 25 19:43:44.747: %PFREDUN-4-SUP_FORCE_TO_ROMMON: Supervisor forced to rommon with reason: In-chassis Standby is not supported in this version
Resetting .......
I try introducing the command : switch virtual in-chassis standby switch 1 enable; and after that I try to boot the sup(rommon) but the result is exactly the same.
Please, I need to know if is necessary to change to another IOS version or introduce another adicional configuration.
Config Applied:
switch virtual domain 100
switch mode virtual
interface Port-channel10
no switchport
no ip address
no platform qos channel-consistency
switch virtual link 1
!
interface Port-channel20
no switchport
no ip address
no platform qos channel-consistency
switch virtual link 2
!
interface TenGigabitEthernet1/5/4
no switchport
no ip address
no cdp enable
channel-group 10 mode on
!
interface TenGigabitEthernet1/5/5
no switchport
no ip address
no cdp enable
channel-group 10 mode on
!
interface TenGigabitEthernet2/5/4
no switchport
no ip address
no cdp enable
channel-group 20 mode on
!
interface TenGigabitEthernet2/5/5
no switchport
no ip address
no cdp enable
channel-group 20 mode on
!
Best Regards
