Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,I have configured 2 6509E chassis with two 2T supervisors in each chassis. We are using de IOS version 15.1(1)SY.We have a VSL with 2 TenGig interfaces.After to apply the command : switch convert mode virtual , the Sup Standby in each ch...
Hi everybody,Our customer is try to make a configuration by web interface menu:Admin > Collection Settings > InventoryAfter select the menu below they always received this message:Error in starting acquisition: unable to connect to serverI need to kn...
Hi everybody,I am seeing this VTT enviroment values (extracted with the command show environment alarm threshold) in 3 7600 differents boxes.VTT 1 OK: OK threshold #1 for VTT 1 OK: (sensor value != 0 ) is system minor alarmVTT 1 outlet temperatur...
Hi,I have installed Insight ( with MySQL ) and CM (with Oracle 10g) in the same server. When I after to configure the Remote Database always reiceive the same reponse: Configuration Test Failed.The data introduced are correct, but I dont know where i...
Hi, I´m installing a SM 3.7.0 on server SunFire x4200 (with AMD64 not SPARC procesor) with Solaris 10.And after to run ./install-sm.sh I received this messages:# ./install-sm.sh -oinstall-sm.sh: Starting SM installation sequenceinstall-sm.sh: 0instal...
Hi Reza,The VSS is working right now, but only with one supervisor by chassis.When I introduces the command show module the second supervisor appears as UNKNOWN, and it must appears STANDBY(CSSO).Regards.
Hi Aru,Thanks for your answer, I already had this information but I want to confirm if this values (100C and 115C) are fixed and is not possible or necessary change it.Regards
