09-10-2018 10:16 AM - edited 03-08-2019 04:07 PM
Working on configuring new C9300 switches. In the getting started guide for configuration it indicates I can plug PC into any unmanaged network port on the switch and use the WEBUI site at 192.168.1.1 to configure the switch. The PC must be configured for DHCP and it should get an IP from the switch.
This is not working and looking to see if there is a service to start on the switch.
I can connect to the switch console port and access the cli. Limited CLI experience and would prefer the GUI to configure the switch.
Solved! Go to Solution.
01-28-2019 08:25 AM
01-28-2019 08:32 AM
Mark, there's no option for me to continue even if unsecure.
01-28-2019 08:31 AM
Hi Mark, I tried http://192.168.1.1 as well even though the instructions state to use https and it doesn't work either. Nothing ever displays and it keeps saying Waiting for 192.168.1.1
01-28-2019 08:40 AM
01-28-2019 08:51 AM
Still no joy. I tried changing the TLS settings in IE every which way and it still doesn't work. Any other ideas? Thanks.
01-28-2019 08:54 AM
01-28-2019 09:14 AM
I've tried everything you suggested and still no go. So odd. I would really love to get this working somehow.
01-28-2019 12:36 PM
Hi Mark, anything else you could recommend or should I open a TAC case? Thanks again for your assistance.
01-28-2019 01:38 PM
01-29-2019 06:56 AM
01-29-2019 08:37 AM
08-23-2019 03:27 PM
Hi Neebaum,
I have same issue. I can't get an access to Web GUI on Catalyst9200.
Could you tell me how to get an IP address from the switch?
Did you change anything on it?
08-26-2019 02:37 PM
Hi Kezumi, I never got it working. As for the IP is should already be on the device by default but as I stated I never got it working so I ended up just configuring it via CLI. I wasted too much time trying to get the web ui to work. If you get it working or if anyone else does please let me know how as it would be nice to see how easy it is to set up via the web ui. Thanks & good luck.
09-19-2019 07:28 AM
Hi neebaum,
Thank you for your reply. I noticed your answer today. Sorry for my late response.
I've tried many ways, but never been given GUI access. I gave up, too.
05-20-2019 03:02 AM
Hi Maek,
I can access the UI but the default credentials does not work. i put cisco as username and my SN as password
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide