04-13-2012 01:49 PM - edited 03-07-2019 06:07 AM
I have topology as follows
Like shown in the pic, I am using SVI Vlan 70 with IP shown on both of the Switch R1 and R2. R1 is in Active state while R2 is in standby state.
The Problem is,
R1 is able to ping the IPs, 172.30.70.3 & 172.30.70.1
R2 is able to ping IP 172.30.70.2 but unable to ping 172.30.70.1
R4 is able to ping both 172.30.70.2 & 172.30.70.3 but unable to ping 172.30.70.1
Whats wrong?? I am attaching "Show standby" command on both the switched R1 and R2
As a side note : everything was working fine untill the whole topology reloaded.
04-14-2012 04:04 AM
it looks like a dynamips related issue. It is not worth troubleshooting this on Cisco forum.
Riccardo
11-29-2012 11:14 AM
Ved,
I had the same issue in GNS, and changed to HSRP ver 2 and afterwards was able to ping virtual ip from standby and the client.
The command is
conf t
int vlan 10
standby ver 2
end
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide