When requesting dynmic ip i get the following error: dhcp failed apipa

[302628167]

Hi,

I can't figure out why my DHCP server is not able to provide IPs to end-clients on a vlans controlled by a multi-layer switch. When the end clients are assigned static IP addresses they get the message "dhcp failed apipa is being used" and i can't figure out where the problem is. Does any one have a solution or knows what i did wrong?

Thank you,

B.

[Georg Pauwen]

Hello,

there are no DHCP pools anywhere. You can use the router, the L3 switch, or the DHCP server. I used the router to create the DHCP pools. Your ip helper-addresses need to be changed to 100.0.0.1. 

Also, the server has the same IP address as the default gateway.

Attached the revised file.