09-29-2010 08:36 AM - edited 03-06-2019 01:14 PM
Hi all,
On etherchannel i know when we create etherchannel that link is logical link.
my question is why always port channel always start with Logical slot/port = 14/1
Is it standard convestion that Port channel always start with slot 14?
many thanks
mahesh
Solved! Go to Solution.
09-29-2010 10:55 AM
Hi mahesh,
There is an internal logic to determine output port/ports in Catalyst6500 system
and some other products that is refered as Local Target Logic (LTL).
When you configure a port-channel and assign physical port/ports, a LTL will be allocated to
the port-channel and the physical port/ports will be programmed in the LTL.
Logical slot 14 is reservid for port-channels, 15 is reserved for primary supervisor and
16 is for secondary supervisor.
TAC or engineering team check them when doing some type of troubleshooting but
it is not important for most of users.
Regards,
Kimihito.
09-29-2010 10:55 AM
Hi mahesh,
There is an internal logic to determine output port/ports in Catalyst6500 system
and some other products that is refered as Local Target Logic (LTL).
When you configure a port-channel and assign physical port/ports, a LTL will be allocated to
the port-channel and the physical port/ports will be programmed in the LTL.
Logical slot 14 is reservid for port-channels, 15 is reserved for primary supervisor and
16 is for secondary supervisor.
TAC or engineering team check them when doing some type of troubleshooting but
it is not important for most of users.
Regards,
Kimihito.
09-29-2010 11:15 AM
Hi,
Many thanks for reply.
is there any command which we can use to see these Logical slots?
mahesh
09-29-2010 03:22 PM
Many thanks for explanation
mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide