Windows NLB on a 3750 Switch Stack and port channels

[actkillerby]

This has probably been asked before but I have had a search and cant find a complete answer.

We have 2 x 3750 switches in a stack.  We use these for connecting servers that have teamed NICs, i.e. the 2 connections are each connected to a different switch in the stack and then configured as a port channel and this allows higher throughput and some resilience should a NIC or switch fail.

We have a couple of new web servers being installed and these have to use Windows NLB and we would like to connect using our 2 switch stack, one NIC in each switch.

With NLB do we have to put the cluster mac address as a static entry on the switch ports

i.e.

mac address-table static 03bf.ac14.d14b vlan 602 interface GigabitEthernet2/0/4 GigabitEthernet1/0/4 Port-channel4

I believe I have this correct but wanted a sanity check first.

Thanks

[acampbell]

Hi,

Try reading this link

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/107995-config-catalyst-00.html

Hope this helps

Regards

Alex