cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1293
Views
5
Helpful
2
Replies

WS-X6708-10G-3CXL doesn't work on WS-C6506-E

inevalink
Beginner
Beginner

Hello,

we can't start WS-X6708-10G-3CXL on WS-C6506-E

here is more info:

SW0#sh ver

Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SRA7, RELEASE SOFTWARE (fc2)

SW0#sh module

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

1   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL1206FBVM

2   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX     SAL0917A0MC

3   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       SAL1232ZH7F

4    8  FRU type (0x6003, 0x3F8(1016))         WS-X6708-10GE      SAL1625EX75

6    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL092756DS

Mod MAC addresses                       Hw    Fw           Sw           Status

--- ---------------------------------- ------ ------------ ------------ -------

1  001e.f783.9bf4 to 001e.f783.9c0b   3.1   12.2(18r)S1  12.2(33)SRA7 Ok

2  0013.c424.34b8 to 0013.c424.34e7  10.1   7.2(1)       8.6(0.259)CA Ok

3  0022.55f4.04c0 to 0022.55f4.04d7   3.2   12.2(18r)S1  12.2(33)SRA7 Ok

4  442b.034f.6f98 to 442b.034f.6f9f   3.5   Unknown      Unknown      PwrDown

6  0012.dae4.7f10 to 0012.dae4.7f13   4.4   8.1(3)       12.2(33)SRA7 Ok

Mod  Sub-Module                  Model              Serial       Hw     Status

---- --------------------------- ------------------ ----------- ------- -------

1  Centralized Forwarding Card WS-F6700-CFC       SAL1205F0ES  4.0    Ok

3  Centralized Forwarding Card WS-F6700-CFC       SAL1226V4AS  4.1    Ok

4  Distributed Forwarding Card WS-F6700-DFC3CXL   SAL1626FA3U  1.7    PwrDown

6  Policy Feature Card 3       WS-F6K-PFC3B       SAL092753DG  2.1    Ok

6  MSFC3 Daughterboard         WS-SUP720          SAL09253GB9  2.3    Ok

Mod  Online Diag Status

---- -------------------

1  Pass

2  Pass

3  Pass

4  Not Applicable

6  Pass

we did try on conf t mode "power enable module 3" and it didn't work

Oct 28 15:01:06: %C6KPWR-SP-4-UNSUPPORTED: unsupported module in slot 4, power not allowed: Unknown Card Type.

Oct 28 15:01:56: %SYS-5-CONFIG_I: Configured from console by bill3 on vty0 (89.223.47.133)

Oct 28 15:03:36: %C6KPWR-SP-4-UNSUPPORTED: unsupported module in slot 4, power not allowed: Unknown Card Type.

--

SW0#sh power

system power redundancy mode = combined

system power total =     6325.20 Watts (150.60 Amps @ 42V)

system power used =      1038.66 Watts (24.73 Amps @ 42V)

system power available = 5286.54 Watts (125.87 Amps @ 42V)

                       Power-Capacity PS-Fan Output Oper

PS   Type               Watts   A @42V Status Status State

---- ------------------ ------- ------ ------ ------ -----

1    WS-CAC-4000W-INT   3795.12 90.36  OK     OK     on

2    WS-CAC-6000W       5771.64 137.42 OK     OK     on

                       Pwr-Allocated  Oper

Fan  Type               Watts   A @42V State

---- ------------------ ------- ------ -----

1    WS-C6506-E-FAN       98.70  2.35  OK

                       Pwr-Requested  Pwr-Allocated  Admin Oper

Slot Card-Type          Watts   A @42V Watts   A @42V State State

---- ------------------ ------- ------ ------- ------ ----- -----

1    WS-X6724-SFP        125.16  2.98   125.16  2.98  on    on

2    WS-X6548-GE-TX      125.16  2.98   125.16  2.98  on    on

3    WS-X6724-SFP        125.16  2.98   125.16  2.98  on    on

4    WS-X6708-10GE       473.76 11.28     -     -     on    off (not supported)

5    (Redundant Sup)       -     -      282.24  6.72  -     -

6    WS-SUP720-3B        282.24  6.72   282.24  6.72  on    on

2 Replies 2

Reza Sharifi
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Hi,

Can you move the module to a different slot and try again?

Also, you are running a very old version of IOS.  Try a later version of SXi or SXJ.

HTH

Hi,

DFC3CXL cards require newer IOS.

tab 5 "Minimum Software Requirements for New Distributed Forwarding Cards" of

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps8802/ps6970/ps6017/prod_bulletin0900aecd806afd81.html

WS-F6700-DFC3CXL

• Cisco IOS Software Release 12.2(18)SXF5 and later with Cisco Supervisor 720 3B if using with WS-X6708-10G-3CXL line card

• Cisco IOS Software Release 12.2(33)SXH and later with all the line cards mentioned above

So as Reza wrote you need to upgrade software.

Riccardo

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers