Xmodem aborting issue with transfer of file

[Rebekah03]

I'm having issue with transfer of file with xmodem. I set BAUD rate on switch to 115200 and on extraputty to 115200. I turned off X0N/XOFF and I use RTS/CTS. When I choose xmode send or xmodem 1k it connects, transfer, then it shows aborting... The file does not beginning to transfer.

[Reza Sharifi]

Have you tried using lower baud rates (38400, 9600)?

[Peter Paluch]

Hi,

In addition to Reza's suggestion, I believe that your flow control setting is wrong. You are using RTS/CTS, but this is a hardware-based flow control, and to my best knowledge, Cisco does not implement this on its console ports. Please deactivate the RTS/CTS, and use the XON/XOFF software flow control instead.

Best regards,
Peter