10-23-2012 01:12 AM - edited 03-18-2019 12:01 AM
Hello!
Please post pictures of CTS-SX20-QS-WMK and CTS-QSC20-WMK.
Are they used for mounting the codecs or for the display screens?
Thanks in advance
10-23-2012 01:17 AM
Hi,
Wall mount kits are for mouting the codec to the wall.
I have attached a photo of a sx20 with a wall mount kit ( the little bar in the top of the picture)
If you require a whole mount then I would recommend you to look at the profile series systems.
//Marius
10-23-2012 01:28 AM
Thanks Marius!
Am also ordering C20s so I want to know how the respective wallmount kit looks like.
Regards,
10-23-2012 01:35 AM
Hi Kelvin.
I do not have any pictures of the wall mount it self, but it is illustrated in this pdf.
Just a recap, the wallmounts are there to
1. mount on the wall
2. hide cables going in and out from the codec.
//Marius
10-23-2012 09:31 AM
Hi Kelvin
link below is for the SX20 wall Mount Installation
BR
Dean
10-23-2012 11:01 PM
Thanks for the information.
So can I use remote control after I have installed the wall mount kits.
OR
The wall mount kits can only be used with touch pad controller.
10-24-2012 12:23 AM
Hi Kelivn.
There is a IR sensor on the codec, and there is a IR sensor in the camera.
So you can use the remote by pointing it at the camera ( which is pointing towards you anyway if you are in a call )
//Marius
04-20-2015 12:28 PM
Also be aware you can only use the remote if the touchpad is disconnected. as soon as you register the touchpad, the remote will not work
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide