C60 ISDN Link only first BRI port only works

[preston.brown.ctr]

I have been able to connect to all of my ISDN wall ports and make a video connection.

As long as I use the 1st port from left of ISDN Link the connection is good.

Using the 2nd Port no connection can be made.

I can use the 1st Port and any of my 4 ISDN wall ports and make a connection.

So my 4 ISDN numbers are good. And my 1st port on my ISDN Link is good.

The ISDN Link config settings:.. H320 Nettype: BRI, Bonding, Rebonding(on), timer(normal)

ISDN parallelDial(on).

The status xml attached.

My question is why is only the 1st ISDN Link port able to complete a connection?

My ISDN Link Status is here:

BRI

Interface1

layer1Alarm:

layer2Alarm:

status: ready

Channel1

status:connect

type:BChannel

Call7

callingNumber: 'the number i can connect to'

causelocation:

channelcause:

Channel2

status: disconnected

type: BChannel

Call 9

calling#:

causeLocation: 0

channelCause: 17

Interface2

status: ready

Channel1:

status:disconnected

type:Bchannel

Channel2:

status:disconnected

type: Bchannel

TIA

[Dharmesh Nandoria]

Hi Preston.

Can you please provide xconfig , xstatus for codec and ISDn link in text format ( capture from putty)

You can try factory reset to link to isolate any config issue . If link is on IL 1.0 then upgrade it to IL 1.1 and codec to TC 6.x.

If it is new install then it may be issue with service provider's ISDN configuration .

hth

Kind regards,

Dharmmesh