Cisco Table Microphone (CS-MIC-TABLE-J) wiring

[engrave15]

Hi. 

I would like to ask regarding Cisco Table Microphone (CS-MIC-TABLE-J). I have an existing SX80 and I would like to use the CS-MIC-TABLE-J, however the connection for SX80 codec is Euroblock (the Cisco Table Microphone is 3.5mm). I would like to remove the 3.5mm jack and directly connect it to SX80 codec. Anyone could advise the wiring assigment of Cisco Table Microphone (+,-,ground, mute). Appreciate the help. Thank you.

[Nithin Eluvathingal]

The below  product may help you or not. Terminal block 4-pin to 3.5 mm. Jack female (4-pin stereo)

https://www.av-connection.com/?PGr=10953

[e.verhagen]

Very old thread, but the 3.5mm TRRS pin out is Tip=[+] Ring1=[-] Ring2=[Mute] Sleeve=[Gnd]