02-27-2007 12:11 PM - edited 03-17-2019 08:57 PM
Hi pros,
I've installed a CME and I have VTA on the phones, the video works great, but when I have video on, I am not able to make any calls out to the PSTN.
Once I exit the VTA application on the PC, I am able to call.
Please HELP!
Thanks,
Joe
Solved! Go to Solution.
02-28-2007 06:39 AM
Joe,
I had the exact same problem. See the link below:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080569b65.shtml
It refers to CCM, but the fix is applicable to the voice port. The short version of it is, go to your voice-gateway, go to voice-port config for your PSTN trunk and enter bearer-cap speech. This should get you rolling.
Remember to rate helpful posts!
Jim
02-28-2007 06:39 AM
Joe,
I had the exact same problem. See the link below:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080569b65.shtml
It refers to CCM, but the fix is applicable to the voice port. The short version of it is, go to your voice-gateway, go to voice-port config for your PSTN trunk and enter bearer-cap speech. This should get you rolling.
Remember to rate helpful posts!
Jim
02-28-2007 12:27 PM
Jim,
You're the man!!!
It works great now. TAC hasn't figured out this yet.
Thanks man,
Joe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide