TelePresence and Video Infrastructure

Hi,I try to connect a video endpoint with a BRI configured in Network Side.Incoming and outgoing calls use a PRI.BRI Layer 1 is OK, layer 2 is AWAITING_ESTABLISHMENT.When I do debug isdn q921, I can see only NET TX -> (I don't have NET RX <-)Does som...

I made a connection from PBX to 3825 Gateway. We use busyout inter serial xx command and If Serial port is down, voice port is down. But there are two hops between 3835 gateway and sip proxy. if 2. hop is down, voice port is not down. Can I use "busy...

hi all ,i'm performing h323 video conf with polycom solution (PVX and Ipower)(one endpoint on private lan one endpoint on internet)between ipower and pvx all works fine ,between pvx and pvx video works but i can't use h239 PVX option.it looks like a ...

Hi,Can someone tell me the debug command I can use to capture digits sent to my gateway(AS5350) from PSTN?It seems my PSTN is not sending all the required digits.Thanks,Kayode

Hi All; we have switched from TDM to SIP trunk. after that call forward to voicemail and also automated attendant don't work. then I changed VM pilot number to full number instead of 6000. still when inbound call is received, and called party doesn't...

Hi,I am in a situation, where I have 2 2811's CME systems connected via an E1 trunk.Is it possible for me to configure 1 of the routers to simulate some PBX functionality ?Specifically, I want to test the ability of one router to do "hookflash transf...

Hi all,I am confused to set QoS for both Video and Voice in VC. Would you provide any sample of configuration like marking what ports and config of CBWFQ?Thanks and Regards,mak

Hello, we have a cisco 1720 with vonage units and mitel ip phones.How/what can we do in the cisco to prioritize voice over data traffic? I know the port numbers of the voip devices...thanks

Is there any solution by Cisco for IP Surveillance ? If the details are there on the Cisco site, where can i find them?

I have 2-3 7985's that when the user places an audio call, they will reboot about 5 secs into the audio call. They are all running the same load 4.2.1.Anyone else seen this?

Does h323-disconnect-cause always have the same value in Stop/originate and Stop/answer accounting? If no, where can I learn its semantics for each of two cases? Many thanks for the fast reply!

The output of "show voice call summary" displays some calls with "CODEC: cisco".Any one knows wich codec is this?

Hi,I've a scenario where an IP Phone has a CfALL to a mobile. When the ip phone is dialled from external the caller gets busy whilst when dialled from internal the call is successful. Any ideas??Running MGCP and the voice card is a VWIC-xMFT-E1

Hello to everybody!Problem Details: During implementation of IPTV service we faced a problem of abnormal behaviour of GSR.First of all - we cannot see the normal pim-neighbors table (it cannot define a type of connection with P-router) Secondly, when...

Hi All,I've got a number of 2811 routers with e1 WICs connecting to PBXs. I was wanting to run a debug on the channel but the debug isdn option is not even there. I see someone else was having a problem as well. The Bug Toolkit suggested that there m...