CMM with 6 port E1 how to configure trunk groups

[jeroenhermans]

Posted in wrong section. I opened a new post in IP-telephony.

Hi,

We have a cisco WS-SVC-CMM running IOS wscmm-i6s-mz.123-8.XY7.bin and 1 6 port E1 module inserted.

I'm trying to setup a trunk group that I want to assign to 2 E1's but the system does not accept the command

trunk group. Is this not supported by the module or is it an issue with my IOS version?

Thanks for your help,

Jeroen

[bwilmoth]

Cisco CallManager assumes all loop-start trunks lack positive disconnect supervision. We recommend that you configure trunks that have positive disconnect supervision with ground start signaling.