07-08-2019 07:09 AM
good morning,
we were implement collaboration solution for customer, when client dial phone number (extension or external number) after press dial the system add @domain.
Is this normal or we can change a parameter to change this mode????
with B2B via URI calls is OK. (via ExpressWay-C and E) and acces to spaces on CMS all this calls are OK.
The endpoints are registered on Cisco Call Manager system.
Thanks and best regards,
Camilo.
mmxix
Solved! Go to Solution.
07-08-2019 06:36 PM
This is normal as a SIP URI must have an @domain part. Without it, you don't have a valid address for the endpoint to dial. If you need to strip or modify the @domain part, you can do this on your call control infrastucture (Expressways).
Please remember to mark helpful responses and to set your question as answered if appropriate.
07-08-2019 06:36 PM
This is normal as a SIP URI must have an @domain part. Without it, you don't have a valid address for the endpoint to dial. If you need to strip or modify the @domain part, you can do this on your call control infrastucture (Expressways).
Please remember to mark helpful responses and to set your question as answered if appropriate.
07-09-2019 05:43 AM
Good morning,
Thank you very much for your support.
have a good day.
Best regards,
Camilo Barbaste A.
mmxix
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide