I have my analog phones under the control of CME but when i try to press the **5 to pickup a call I get a fast busy the first time i press the * prefix. Any ideas why this is ? Parts for config below
stcapp ccm-group 1
stcapp security trustpoint SJS253-cme
stcapp security mode encrypted
stcapp
!
stcapp feature access-code
!
!
!
stcapp supplementary-services
port 1/0/0
fallback-dn 3328
port 1/0/1
fallback-dn 2001
port 1/0/2
fallback-dn 2002
port 1/0/3
fallback-dn 2003
port 1/0/4
fallback-dn 2004
port 1/0/5
fallback-dn 2999
!
stcapp call-control mode feature
!
sccp local GigabitEthernet0/0.100
sccp ccm 10.30.58.62 identifier 1 version 7.0 trustpoint SJS253-cme
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
signaling dscp cs5
!
telephony-service
secure-signaling trustpoint SJS253-cme
tftp-server-credentials trustpoint SJS253-cme
server-security-mode secure
device-security-mode encrypted
no auto-reg-ephone
authentication credential cisco cisco
max-ephones 58
max-dn 300
ip source-address 10.30.58.62 port 2000
ip qos dscp cs5 signal
service phone garp 0
service phone spanToPCPort 1
service phone webAccess 1
system message Whiting Field
cnf-file location flash:
cnf-file perphone
load 7915-12 B015-1-0-3
load 7915-24 B015-1-0-3
load 7942 SCCP42.8-5-3S
load 7962 SCCP42.8-5-3S
time-zone 8
voicemail 7800
max-conferences 8 gain -6
call-forward pattern ..........
moh flash:music-on-hold.au
multicast moh 239.30.13.1 port 2000
web admin system name cisco password cisco
dn-webedit
time-webedit
transfer-system full-consult
transfer-pattern ....
fac standard
create cnf-files version-stamp Jan 01 2002 00:00:00
!
