Steven, Thanks for the script this saved us for an install we had to do, you don't how long we worked at getting the certs to work with the phones. I plan on running this script again for another installation right now I have everything setup but wanted to know if i run this scirpt successfully but need to upgrade my flash on the router do you believe this will cause any problems and what should i look for to move any files that were saved to flash for secure cme. ... View more

Yes that is correct the translaton pattern was added to the correct dial peer, and also i tested the rule using the "test voice..." command, i will have to check and make sure the correct dial peer is being used. I think talking to the telco is the next step. ... View more

I first went to telepony-service and added the command caller-id block *888, then dialed a number and the call did not block I then put in a translation pattern so that *67 will be added to the number voice translation-rule 15 rule 1 /^888\(..........\)$/ /*67\1/----for dialing a 10 digit number I tested the pattern and it worked, i also added a dial peer for the 888 number to go out. The call is able to go out but once agian the number is not being blocked ... View more

I tried forwarding out *67 along with the number but when i make a test call using *67 i do not see the number being blocked I think that has now to do with the service provider not blocking the number when *67 is passed along ... View more

This action was not avaiable using the cca so i tried doing this through the CLI . When i went to outbound calls and to caller id it was just a message speaking of the provider providing caller id so no way to do this from cca ... View more