TelePresence and Video Infrastructure

Hi all,does anyone had bad experience when using a Firewall Traversal solution with Juniper SSG 520, Firmware 6.1.0r1.0 ?The Juniper has all VoIP/H323/SIP ALG disabled, but when some H323/H460 traffic pass this FW, it cuts the TCP signaling after a f...

hiOur Cisco Telepresence server (8710) connected to VCS working with CTS-3010 endpoints (with presentation codec) registered with CUCM for presentation sharing during multipoint meeting.We found that when sharing presentation from  a CTS-3010 to othe...

Hi GuysWould anyone have any knowledge of integrating the CTMS with Conductor?-  Is this a current release or roadmap feature for Conductor?-  What version of CTMS firmware would be required?-  Are there CTMS server hardware requirements specific to ...

Hello I have a strange behaviour on a Profile 2000MXP.The buttons Selfview and Layout have no effect on the display, (the remote control works on a other system)And when I make a call to an other system, the system connects but I keep seeing my own c...

I have a Precision HD 12x camera connected to a C40 that is not working properly. The codec and camera have been in use for some time but recently the room where the unit is located was renovated. After the renovation the camera is now powered by an ...

hello i need your helpwhat license need to register two video endpoint SX20 on Cisco Unified Comunnications Manages Business Edition 8.6? i can register telepresence endpoint on CUCM BE 6000 8.6 ???thanks for you HELPJCA.

I upgraded to VCSx7.1/TMS 13.2 over the weekend and I can edit a users FindMe from the 'Edit in FindMe User Portal' link on the user but when I try to login as the user directly to the portal I cannot login, my TMS server is standalone (not part of a...

Hello,Are there any caveats for registering MCU 4500s to CUCM vs registering it to VCS. In my case, I have all endpoints registered to CUCM and have a SIP trunk to VCS. I also have a TMS for scheduling.Thanks

hi,I have a 2801 CME and 2 fxo lines. Some times when both lines are seized (because of incoming and outgoing call) and after the phones are on hook the lines are still seized and are not released mostly i have to unplug and replug the fxo line from ...

hi,I have a 2801 CME and 2 fxo lines. Some times when both lines are seized (because of incoming and outgoing call) and after the phones are on hook the lines are still seized and are not released and when i removed the cables from fxo port, the led ...

Where can I find the documentation the describes how to convert a 7985 (T150) from a SCCP load to either an H.323 or (if available?) a SIP load so I can register it to my VCS-C/E instead of just CUCM.

what's the best way to download the SIP messages from Telepresence ?