09-21-2018 01:45 AM - edited 03-18-2019 02:22 PM
Hey guys,
Now, I want to control sx20 Codec (Call, Pan / Tilte Camera, ...)
Because the codec does not have an Rs-232 port so I have to use a USB port.
But I can not connect RS-232 (Extron IPCP Pro 350) to Codec
All your idea is your help for me
09-21-2018 06:19 AM
the default baud rate is 38400 - did you change it? I believe you have to go to the command line to change the port settings.
You definitely can do this if you have the right connections and settings - see the admin guide for details:
09-25-2018 12:04 AM
The default speed for the serial port on the SX20 is 38400, not 115200. This is mentioned in this thread: SX20, Control with RS-232. You also need to make sure (as also discussed there) that you are using one of the supported USB->Serial adaptors (ones with the PL2303 or FTDI chipset). Cisco recommends using the UC232R-10 USB to RS232 (FTDI) adaptor for the most tested and stable serial connection.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide