Interconnect 2 NON IP PBX's over MPLS

[bsoth]

I have 2 Mitel PBX's that currently communicate over channels 19-24 of a PtPTt1. The Routers are configured to take 19-24 and point them out another T1 interface on the router where that is directly connected to the PBX T1 interface. these 2 MItel PBX's are not IP.

So we are now going to MPLS and once this is done, I lose the physical PtP circuit and thus lose that channellization. So the question is How can I configure VoIP router to router and interconnect my 2 PBX's?

Thanks!

Bryan

[paolo bevilacqua]

Have you considered hiring a professional, or alternatively studying the documentation in order to complete the task ?

[bsoth]

Yes I have read the documentation.  We dont need smart ass comments like this here. If you have something to contribute then go ahead but your comment about hiring a professional is just a wise ass move on your part. Keep your mouth shut next time.

ll

[frlindse]

If the two PBX's use "proprietary" signaling you could set two gateways linked via TCCS.  Here is the doc, it's old but still valid

http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dt_tccs.html