09-10-2015 04:19 PM - edited 03-18-2019 04:58 AM
Hi all,
I have a customer who has an issue with video calls dropping out after 15 mins.
The customer reports that this happens with calls to their SX20 endpoint. The remote device could be either an 8945 IP phone, or a Jabber for windows client.
ie point-to-point call from SX20 to CP-8945G, or SX20 to J4W client.
The call drops out after 15 mins (ie 900 seconds).
Usually I would think this might be an issue with something like "Options ping". But this is an internal call.
Can anyone suggest a place to start?
Thanks
09-12-2015 05:14 AM
Hi Dana,
This issue is more likely due to Session-Refresh timer. We (TAC) have created a external article for this issue. To begin with, I'd refer you to the below link:
There are a few more questions to follow:
1> Are all the endpoints registered to CUCM? Or are some registered to VCS?
2> Do you have any logs to share?
Alternatively, you can raise a TAC SR as well.
Cheers.
/Chirag
09-16-2015 10:20 PM
Hi Chirag,
The endpoints are all registered directly to CUCM version 10.5(1)SU1?
Cheers
Dana
09-16-2015 10:24 PM
Hi Dana,
Kindly provide CUCM detailed level logs to investigate further.
Cheers,
/Chirag
09-22-2015 12:48 PM
I have ran into this in the past and firewall configuration was the culprit. Try the call between endpoints on the same subnet and see if the issue persists.
09-18-2015 07:52 AM
Might be this bug(CSCuv06688)
https://tools.cisco.com/quickview/bug/CSCuv06688.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide