09-11-2017 09:59 AM - edited 03-18-2019 01:27 PM
Dear All
I have the following Situation:
If I made a Call via Conductor only 1 screen on the IX5000 is active, but in selfview i can see all the screen is connected and active.
call made - (IX5000,SX80,SX20,DX70) call Conference via --> Conductor -->TP 8710
conductor - conference template configured maximum screen 3
quality configured - fullhd multichannel
Any Idea or Input appreciated !
Regards,
Ashiq
09-12-2017 03:26 AM
Under the conference template in conductor under advanced setting have you enabled
I am assuming your call control is CUCM, check if you have enabled the below on the SIP Profile.
And on the CUCM under device settings multistream mode is set to AUTO.
Regards,
Alok
09-12-2017 08:29 AM
09-19-2017 12:53 AM
dear Alok,
any update . kindly advise if anyother options i can try to work it.
Ashiq
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide