10-01-2015 11:32 PM - edited 03-18-2019 05:03 AM
Hallo,
CUCM 10.5
SX20 , 7.3.3
Touch 10
My Problem :
After the new start I do the same procedure (1 & 2) and again and again and again and it nothing happens, I have done a factory reset and start with the pairing but nothing.
Thanks for your support
Homayoun
Solved! Go to Solution.
10-08-2015 03:22 AM
Hi Shawnangelo,
Thanks for your Replay and sorry for my late answer.
The solution was easy , we have a cable problem after changing the cable it did works.
Thanks a lot
Best regards
Homayoun
10-02-2015 03:06 PM
Have you ensured the following:
SX20 and Touch 10 can both reach each other over the network and have valid IP addresses?
Pairing mode is enabled on the SX20 and has not expired due to timeout?
10-08-2015 03:22 AM
Hi Shawnangelo,
Thanks for your Replay and sorry for my late answer.
The solution was easy , we have a cable problem after changing the cable it did works.
Thanks a lot
Best regards
Homayoun
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide