Hi, we have a configuration with a Cisco Sx80 + Touch 10, 2 cisco P60 cameras, and a Creston 300 with an Android tablet and Creston Go Software.
The monitors, Android Tablet, the Creston, are on a switch with a 172.xxx subnet and the cameras and the touch have ips assigned by the Cisco Sx80 from a 169.xxxx range.
The Creston and the NS80 have a connection through RS232.
The movement of the cameras, zoom, etc, from the Touch 10 and from the Cisco SX80 works fine, but it does not work from the tablet that manages the Creston Go.
We think it could be because the cameras and Creston are in different IP range.
So, is it possible to tell the Cisco SX 80 to assign ips from the 172.x range instead of 169.x?
Thanks