SX-20 Registration with Expressway-e over Internet

[ibrahim.kayali]

Hello ,

I'm looking for cisco documentation that explain SX-20 supports expressway-e registration over internet or not ? Did you test this endpoint for this purpose and do you have any document about this issue ?

Regards ,

Ibrahim.

[Rishabh Gupta]

HI Ibrahim,

Please refer these documents : 

1. Collaboration Edge TC-based Endpoints Configuration Example : https://www.cisco.com/c/en/us/support/docs/unified-communications/expressway/118696-config-cucm-00.html
2. Registering a SX10 (and TC based endpoints) through Collab-Edge MRA : https://ciscocollab.wordpress.com/2015/11/22/registering-an-sx-10-and-tc-based-endpoints-through-collab-edge-mra/

Regards,

Rishabh Gupta,

*Rate the response if found helpful.

[ibrahim.kayali]

Hello Rishabh ,

Thanks for explanation. However , I need the SX-20 or SX Series support this feature or not.
The documents you sent not contain this information exactly.

Regards ,
Ibrahim.

[Rishabh Gupta]

HI @ibrahim.kayali,

Yes, the document is applicable for all endpoints running TC / CE software.

You can follow it for SX20 as well.

Regards,

Rishabh Gupta

[ibrahim.kayali]

Hello Risbabh ,
Thanks for your confirmation. Expressway-e certificate is signed by COMODO . This 3rd Party CA supports this feature ?

[Rishabh Gupta]

HI Ibrahim,

Yes, "Comodo CA Limited"supports this.

It is already there in the list of Pre-installed CAs in endpoint.

See below:

Ragards, 

Rishabh Gupta

-Rate the response if helpful