cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
331
Views
0
Helpful
1
Replies

TC CONSOLE

wilsondmello
Beginner
Beginner

Dears,

I have C90 with 3 cameras. I setup the TC CONSOLE same layouts for local and remote side. The default is also set and in the Codec is set to auto profile in layout setting.

I made 3 frames for 3 cameras in same screen. I can see also when I press layout in my remote the layout profile is apears.

Now the issue is The remote video I get  is only one camera. but local view is fine. Does anybody face this issue? Please suggests any more settings are required.

Please find the test configuration file attached.

Thank you,

Wilson

1 Reply 1

Paulo Souza
Rising star
Rising star

Hi Wilson, welcome to Cisco Support Community!

What is the resolution negotiated on the call? When activating presentation during the conderence, does the layout on the far end change? Can you test it using 4:3 and 16:9 presentation resolution?

Also tell me what is the video format of your three cameras, 16:9 or 4:3?

My questions might appear not related with the problem, but I took some problems with TC Console where the issue was related to presentation and video input format.

Regards

Paulo Souza

Please rate replies and mark question as "answered" if applicable.

Paulo Souza Was my response helpful? Please rate useful replies and remember to mark any solved questions as "answered".
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers