06-28-2012 10:01 PM - edited 03-17-2019 11:23 PM
HI,
We have installed CTS-MAN (1.8.1.0) an CTMS (1.8.2.0) as endpoints we have CTS-500, MX200 and MX300 Systems.
If I`m in a videoconference i could add one audio only client per site, but i need the ability to add more then one audio only client.
How is that possible ? What i need to do that ?
Thanks
Martin
06-28-2012 11:29 PM
Hello Martin
You need to change default settings (2) in codec/ip phone shared lined on CUCM (maximum number of calls).
That should do the trick.
Regards
Rafal
06-29-2012 01:55 AM
Hi Rafal
Thank`s for response.
I already change this settings on the phone and on the codec i could make more than one call from the cts-500 to an audio endpoint but i could add only one audio device to the conference. I`ve add a conference bridge (ISR) to the MRG and atteched the MRGL to the phone and the codec but i couldn`t see the audio conference on the router.
Regards,
Martin
06-29-2012 02:12 AM
Hello Martin
Are you talking about P2P call or multipoint?
If I understand you correct you want to add more endpoints/devices to the call so that would need multipoint device like Telepresence Server or MCU. Try create multipoint call and the get audio device dial the bridge.
Regards
Rafal
06-29-2012 02:30 AM
Hi Rafal
Yes it is multipoint.
That was you said "Try create multipoint call and the get audio device dial the bridge" is the way that we have to go for a quick solution.
We set up a conf call on a 7936 and bring that to the telepresence session over the confr button on the 7975 or the telepresence touch.
Thanks for the hint ;-)
Best Regards,
Martin
06-29-2012 02:47 AM
No problem Martin
If its multipoint call so that is working as design.
Cheers
Rafal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide